Tesla Model S: Infotainment
Tesla Model S (2012-2026) Service Manual / Infotainment
- Instrument Cluster (Remove and Replace)
- Media Control Unit - Touch Screen (Remove and Replace)
- Media Control Unit - Touch Screen (Remove and Install)
- SIM Card - With SIM Extender (Remove and Replace)
- SD Card - Media Control Unit (Remove and Replace)
- Camera - Forward Facing (Remove and Replace)
- Camera - Rear Facing (Remove and Replace)
- Drive Cycle Calibration - Forward Facing Camera
- Target Calibration - Forward Facing Camera
- Speaker - Front Door Premium Audio - LH/RH (Remove and Replace)
- Speaker - Rear Door All, Front Door Base Audio (Remove and Replace)
- Subwoofer Assembly (Remove and Replace)
- Speaker - Rear - LH/RH (Remove and Replace)
- Premium Boost Amplifier (Remove and Replace)
- Tuner - AM - FM (Remove and Replace)
- Antenna Amplifier - AM/FM and RKE (Remove and Replace)
- Antenna - RF Filter - RH (Remove and Replace)
- Antenna - Satellite Radio - Liftgate-Mounted (Remove and Replace)
- Antenna - Satellite Radio - Roof-Mounted (Remove and Replace)
- Microphone - Bluetooth (Remove and Replace)
- Antenna - GPS (Remove and Replace)
- Antenna - GSM - LH (Remove and Replace)
READ NEXT:
Instrument Cluster (Remove and Replace)
Caution: Before beginning this procedure, prepare a protected
surface to set instrument cluster on when it is removed, such as
placing a fender cover, towel, or other soft material onto a
Media Control Unit - Touch Screen (Remove and Replace)
Backup
Connect a laptop with Toolbox 2.0 or later to the vehicle.
Select Panels > Gateway and Center Display > MCU
Cloner.
Click MCU Backup to backup the MCU files.
If the
Media Control Unit - Touch Screen (Remove and Install)
Special tool required for this procedure:
Supplier
Part Number
Description
SEE MORE:
Installing Child Safety Seats
There are two general methods used to install child
safety seats:
Seat belt retained - these seats are secured using the
vehicle's seat belts. All passenger seating positions in
Model S support the use of seat belt retained child
safety seats.
LATCH retained - these seats attach to anchor
Power Strut - Liftgate (Remove and Replace)
Removal
Open the liftgate.
Support the liftgate in the open position.
Remove the RH C-post upper trim (refer to procedure).
Release the RH rear corner of the headlining from the body.
Note: Do not remove the headlining.
Disconnect the power s
© 2019-2026 Copyright www.tesms.org
